脱模剂使用方法及注意事项 Methods and precautions for deformable agent 1.在喷涂脱模剂之前，应将模具清洗净，不得有铁锈、油污、炭粒和有机物等杂质存在，否则，会降低脱模效果。 The mould should be cleaned and cleaned before spraying, and no rust, oil, coal and organic materials will be allowed to exist, otherwise, it will reduce the effect of stripping. 2.配制脱模剂用水应是纯水（离子交换水或蒸馏水），不得用自来水。 It should be purified water (ion exchange water or distilled water) and no running water. 3.脱模剂量浓度不能太高，涂层不要太厚。 The dosage concentration should not be too high and the coating should not be too thick. 4.根据成型聚合物的种类，选用适宜的脱模剂，效果更好。 According to the type of forming polymer, it is better to choose suitable deformable agent. 5.使用时，要分清外涂型、内加型，一次性、多次性及半永久性的脱模剂，应采用不同的应用工艺。 At the time of use, be able to distinguish between the external and internal, the disposable, multiple sex and semi-permanent deformants, and should be applied in different applications.