模板清理、刷脱模剂及支模的要求
Requirements for formwork cleaning, application of release agent and formwork erection
①支模之前要检查橡胶条是否脱落，发现脱落要马上粘牢或者更换，否则不能支模。
① before formwork erection, check whether the rubber strip falls off. If it falls off, immediately stick or replace it. Otherwise, formwork erection is not allowed.
②橡胶条表面和模板顶口的灰渣必须清理干净之后再支立模板。
② the ash on the surface of rubber strip and the top of formwork must be cleaned before formwork erection.
③每次支立模板之前必须用角磨机将模板表面打磨干净，以提高混凝土表面的光洁度。
③ before erecting the formwork every time, the surface of the formwork must be polished with an angle grinder to improve the smoothness of the concrete surface.
④脱模剂使用色拉油。脱模剂不得多刷，以不成股向下流为宜，防止污染底口的混凝土。
④ use salad oil as release agent. The release agent shall not be applied more than once, and it is better not to flow down as a strand to prevent the concrete at the bottom from being polluted.